Audi A1 Can Filter
Also known as: Trip Odometer – Mileage Stopper – Odometer Correction Tool – Odometer stopper – Can Blocker – Mileage Stopping – Odometer Rollback – Odometer Adjustment – Odometer Blocker
There are two modes that you can select: normal mileage counting, stop mileage counting.
❎ SPEED INDICATOR WORKS:
The activation of the Odometer / Mileage Freezer with functioning speed display in the Audi with virtual cockpit or even with normal speedometer is done by pressing the OK button for 10 seconds, which is located on the steering wheel. Ok button for 10 seconds Press → Mode 1. Ok button for 10 sec.Press → Mode 2
Function mode Mode 1: The actual speed is displayed permanently – only 10% of the actual distance traveled is counted. From 100 km only 10km counted.
Mode 2: The actual speed is displayed permanently – only 30% of the actually driven distance is counted. 100/30
Mode 3: Everything in original condition (module deactivated)
❗️ In each mode, all assistance systems work ❗️
⚙️ The Speedometer Calibration Tool always maintains the last applied settings. Hence, you don’t have to change the settings before starting a car next time.
The device can be activated or deactivated, either while driving or when stationary ⚙️
Special Features of this module:
🔹 The speed display always works , even with the active module. This has the special advantage that all assistance systems in the car function flawlessly. Because without a speed display, the board computer thinks that you are standing and thus does not unlock the assistance systems 🔹
🔸 Temp The cruise control and lane departure warning also works in the activated state, as well as all other assistance systems also work 🔸
🔹 Plug & Play simplified plug-in system. This makes it possible to clamp the speedometer stopper as fast as possible. Without screwing, soldering or cutting cables 🔹
🔸 No soldering or cutting of cables and electronic components required . This saves a lot of time because many car owners are always reluctant to cut or solder something on their vehicle. Our connector system is therefore very innovative and saves the rumknipserei with the scissors 🔸
🔹 No error messages in the speedometer or the navigation. The speedometer filter is a Plug & Play module which is connected between the speedometer and the control unit. This module has all the necessary cable strands your vehicle needs to process. The module suppresses only the signal of the kilometer count and nothing else. Thus, the danger of an error occurring or being displayed remains practically at 0% 🔹
🔸 The installation of the module is fairly simple. You just have to get behind the clock. The way to get there is difficult, but is fast. Once you have reached this point, you should pull out the cable that is in the speedometer out and the speedometer stopper / kilometer filter module between the cable, which was previously in the speedometer and stuck the speedometer. More info can be found in the video above! 🔸
🔹 The speedometer / tacho filter always saves the last adjusted setting . This does not have to be reactivated every time you start your journey. Depending on the state of the module, it is either active or deactivated 🔹
Are you looking for a module for another vehicle? Then press here: 🌐
⚠️ Attention! This device is appropriate only for testing and tuning purposes. However, not for the public traffic.
Similarly, the Speedometer Calibration Tool is not suitable for fraudulent purposes ⚠️